Filter
Top Products
24/29 SD-R5112 Rev.1.0
9. Device Configuration Jumper
9.1. Device configuration jumper (MODE SELECT)
The device configuration jumper is a 6-pin, right angle and header (Molex P/N70203 or equivalent)
with three marked positions.
S M MC SC
S L A S L A
Cable CSEL
S L AS L A
MSC MSC
Vcc
GND
Drive CSEL
(a) (b) (c)
Figure 15
(a) Use CS (CSEL)
The device shall use the host interface signal CSEL to configure the device.
(b) MA (Master): Default Position
The device shall use for the Master.
Default Mode is 'MA'.
(c) SL (Slave)
The device shall use for the Slave.