Filter
Top Products
SD-R5112 Rev.1.0
6. As for mounting bracket to incorporate this product into an equipment,
(1) When this product is incorporated into an equipment by using the mounting screw holes in the right
and left side planes, the clearance between this product and the mounting bracket is too wide;
(2) When this product is incorporated into an equipment by using the mounting screw hole in the
bottom, the surface of the mounting bracket is contorted.
If you use such mounting bracket as the above, this product will become deformed, which may cause
operation failure. Therefore, it is necessary to take account of the mounting bracket which has the
tolerances shown in Fig.1 or whose structure cannot cause this product to deform, as shown in Fig.2
146+/-0.3
146.3
+ 0.2
- 0
less than plane 0.5
Select screws, the length of which
threaded
onto the product is within 3 +/- 0.5 mm
Fig.1
this product
this product
before the fixing
after the fixing
mounting bracket
When a large amount space is left,
insert spacers, etc. to adjust the space
less than 0.5 mm between the product
and mounting bracket.
Fig.2