Filter
Top Products
63
Function setup (DVD)
Output
You can select the video output signal of the DVD
video player to the TV from “Interlace” or “Progressive”.
1) Press C or D to select “Output”.
2) Press A, then press C or D to select “Interlace” or
“Progressive”.
Interlace:
Select when connecting to a composite TV or a TV
equipped with component video inputs but
progressive scan is not compatible.
Progressive:
Select when connecting to a TV equipped with
component video inputs, progressive scan
compatible.
3) Press ENTER.
Warning:
Once “Progressive” is selected when connecting to a
TV progressive scan incompatible, no image will be
seen on the video display.
In this case, you must reset the unit by pressing STOP
on the front panel for five seconds. The video output
will be restored to “Interlace” setting, and a picture will
once again be seen on a conventional analog display.
Notes:
• Some discs may not be played back with the progressive
scanning mode correctly because of the disc characteris-
tics or recording condition.
• Once Progressive scan on, the VIDEO (yellow) and S-
VIDEO outputs are disabled.
Note:
If each setup (pages 60~63) has been completed, the unit
can always be worked under the same conditions
(especially with DVD discs).
Each setup will be retained in the memory even if you
turn the power off.
2F90201A (E)p59-63 4/4/05, 9:03 PM63