Filter
Top Products
OD-A017-02
TOSHIBA DVD-RAM SD-W1111 ‘99/06/26 Version 1.0
Page 30 Product Specification
15. MISCELLANEOUS
15.1 Accessories
Function setting jumper pins 5 pieces.
Emergency eject tool 1 piece.
15.2 A bare disc setting at vertical installation
In case of using a bare disc (ex. DVD-ROM or CD-ROM) at vertical installation, use disc holders on
the tray. Please read the following explanations thoroughly at this time.
1. Draw three disc holders among the four holders on the tray, two pieces are both holders in down
side, one piece is on a rear part in upper side while made to vertical posture as follows.
(Note) Please use 3 pieces holders because the set of the disc becomes difficult when four disc
holders are drawn out.
2. Drawing out a disc holder (pull return) can be easily done with inserting a propelling pencil ahead
in the hole that is installed on the disc holder.