Filter
Top Products
19
Installation and
connection
CONTENTS
Connect the power cord.
• Insert one end in the AC IN socket on the projector.
• Insert the other end in a wall outlet.
Notes
• When the projector is moved from a cold location to a warm location, or when the ambient temperature in the projection room has risen suddenly,
moisture may condense on the lens or the internal optical section to blur the projected pictures. In such a case, leave the projector for an adequate time
(1 to 2 hours, depending on the room’s condition) before using it, so it adjusts to the ambient temperature.
• If the screen is exposed to direct sunlight or other strong light, the projected picture becomes too faint to see. Shut out the light with curtains or other
means.
• If the screen and the projector are not installed properly, the projected picture may be distorted.
3
4
Floor-mounted projector placement (continued)
Light (Orange)
The ON indicator lights in orange and the
projector turns to standby mode.
TEMP LAMP ON
BUSY FAN
TEMP
LAMPON
BUSY FAN
ON/STANDBY
KEYSTONE
SET
AUTOAUTO
EXIT
ENTER
MENU
INPUT
VOL/ADJ.
USB
CONTROL
Take off the lens cover.
Power cord
(Supplied)