Filter
Top Products
16
Using the
Remote Control
Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCR and DVD player models together,
even if they are different brands. If you will be using your TV with a
Toshiba satellite receiver, VCR or DVD player, your remote control is
already programmed and ready to use. If you own different brands of
cable TV converters/satellite receivers, VCRs and/or DVD players, you
first have to program your remote control. (See “Programming the
remote control for use with a cable TV converter/satellite receiver, VCR
or DVD player” on page 17.)
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two “AA” size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
To control a VCR:
Program the remote
control to recognize
the brand of your VCR
(see “Programming the
remote control for use
with a cable TV
converter/satellite
receiver, VCR or DVD
player” on page 17.)
The buttons shown at
right will then control
the VCR.
Set the TV • CBL/
SAT • VCR/DVD
selector to “VCR” first.
Using the remote control with a cable TV converter/satellite receiver, VCR or DVD player
Note:
The TV remote control may or may not
operate your cable TV converter/satellite
receiver, VCR or DVD player. Refer to the
owner’s manuals supplied with the equipment
to see which features are available. In
addition, the original controllers may have
features not available on this remote control.
If you would like to continue to use these
features, you may want to use the original
remote control.
Cautions:
• Dispose of batteries in a designated
disposal area. Do not throw batteries into a
fire.
• Do not mix battery types or combine used
batteries with new ones.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• If you do not intend to use the remote control
for a long time, remove the batteries.
Power
TV • CBL/SAT
• VCR • DVD
selector
Channel
Numbers
Channel ▲▼
To control a cable TV
converter/satellite
receiver:
Program the remote
control to recognize the
brand of your cable TV
converter/satellite
receiver (see “Program-
ming the remote control
for use with a cable TV
converter/satellite
receiver, VCR or DVD
player” on page 17.) The
buttons shown at right will
control the cable TV
converter/satellite
receiver.
Set the TV • CBL/
SAT • VCR • DVD
selector to “CBL/SAT”
first.
Power
CH Enter
Channel
Numbers
TV • CBL/SAT•
VCR • DVD
selector
Input (TV)
Pic Size (TV)
Channel ▲▼
Volume ▲▼ (TV)
TV/VCR
Mute (TV)
Light
Input (TV)
Volume ▲▼
(TV)
Light
CH Enter
Pic Size (TV)
Mute (TV)
VCR controls
3R40121A/E P16-23 6/7/04, 18:5716