Filter
Top Products
38
DSS
®
Satellite Receiver Set-up (continued)
VCR display
6
Select “CONTROL” using PLAY or STOP, and set to “On” or
“OFF” using FF or REW.
On: if your DSS
®
satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
→ Go to step 7.
OFF: if your DSS
®
satellite receiver is
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS
®
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
®
satellite
receiver.
→ Go to step 8.
7
Select “BRAND TYPE” using STOP, and enter a brand code
of your DSS
®
satellite receiver using number buttons. Refer
to the table on the next page.
Example: For a TOSHIBA DSS
®
satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG. three times to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
®
satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step 6.
• The VCRPlus+C system recording is not available on satellite channels.
• The DSS
®
satellite receiver control is not compatible with the cable box
control.
3
®
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
BRA
n
D TYPE no. 36
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
E
n
D : PROG
SET UP
PRESET
PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n
TROL Off on
BRA
n
D TYPE no.99
SENDING A TEST SIGNAL
TO YOUR CABLE BOX
W-609/TSB DRAFT(24-40)01 26/11/99, 8:21 PM38