Filter
Top Products
AgGPS 252 Receiver User Guide 31
Configuring the Receiver 4
4.1 Configuring the AgGPS 252 Receiver to
Operate in RTK Mode
Use the AgRemote utility to configure the AgGPS 252 receiver for
operation in RTK mode. To configure the receiver:
1. Connect the AgGPS 252 receiver to the computer. Turn on the
receiver and start the AgRemote utility.
2. In AgRemote, select Configuration / DGPS Config.
3. Set the Source Select field to RTK.
4. Press
4 then 5 to complete this part of the procedure.
5. For RTK operation, connect the radio to a port. Change the port
input settings for that port to RtkLnk.
4.1 Configuring the Communication Ports
If the AgGPS 252 receiver is to be connected to an external device,
configure Ports A and B so that the proper data type is input to and
output from the receiver.
Ag252_100B_UserGuide_ENG.book Page 31 Thursday, July 28, 2005 4:06 PM