Filter
Top Products
www.urcsupport.com/atlasocap
21
RE-ASSIGNING DEVICE KEYS
The Atlas OCAP 5-Device Remote Control can be set up
to control a second device of an already-assigned type.
For example, to have the unit control a TV, a Cable
Converter, and two audio devices (for example, two
audio receivers), re-assign the unused VCR key to
operate the second audio device as follows:
NOTE: VCR is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
The VCR key is now ready to be programmed for your
second audio device. See “Programming Device
Control” on page 10. To re-assign other device keys,
repeat these and substitute the key sequence using the
following chart:
NOTE: Only one device can be assigned to an unused
device key at a time.
4. Press and hold SETUP until the CBL key blinks
twice.
1. On the remote control, press VCR once; it will
blink once. Then press and hold SETUP until
the VCR key blinks twice.
2. Enter 9 9 2. The VCR key will blink twice.
3. Press AUD once, then press VCR once. The VCR
key will blink twice.
To Re-Assign Perform Key Sequence
VCR as 2nd
AUD key
VCRÆSETUPÆ9Æ9Æ2ÆAUDÆVCR
VCR as 2nd
TV key
VCRÆSETUPÆ9Æ9Æ2ÆTVÆVCR
VCR as 2nd
CBL key
VCRÆSETUPÆ9Æ9Æ2ÆCBLÆVCR
VCR back to
VCR
VCRÆSETUPÆ9Æ9Æ2ÆVCRÆVCR
Atlas OCAP M1056.fm Page 21 Wednesday, April 30, 2008 2:52 PM