Filter
Top Products
12
CHECKING THE CODES
If you have set up the URC-1047 Universal Remote
Control using the Searching For Your Code procedure (on
the previous page),you may need to find out which four-
digit code is operating your equipment.For example,to
find out which code is operating your TV:
1. On the remote control,press TV once.
Then press and hold SETUP until the
TV key blinks twice,then release SETUP.
2. Enter 9 - 9 - 0.The TV key will blink twice.
3. To view the code for the first digit,press 1
once.Wait 3 seconds and count the number
of times the TV key blinks (e.g.,3 blinks = 3)
and write down the number in the leftmost
TV Code box (see below).
NOTE:If a code digit is “0”,the selected mode key
will not blink.
4. Repeat step 3 three more times for the
remaining digits.Use 2 for the second digit,
3 for the third digit,and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes below.
5. To check for other device codes,repeat steps
1 through 4,but substitute the appropriate key
(i.e.,AUD or VCR) for the (Audio or VCR)
device you are checking.Write down the
codes in the appropriate boxes below.
AUD Code
VCR Code
TV Code
Time Warner Houston Manual 11/20/02 3:54 PM Page 12