Filter
Top Products
14
USING THE MASTER POWER KEY
The URC-1047 Universal Remote Control has a unique
feature that allows you to sequentially turn on or off up to
four of your home entertainment devices with a single
key press.
NOTE: MASTER POWERrequires programming and only works in
the CBL mode.If it is not programmed,only the cable converter
will turn on or off.In any other mode, pressing MASTER POWER
once will turn on or off the selected device.
To Program The Master Power Key:
1. On the remote control,press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9- 9 - 5.The last-selected device key
will blink twice.Then press POWER once.
3. For the first device you want in the power on
sequence,press a device key (e.g.,TV) once
and then press POWER once.
4. Repeat step 3 up to three more times to add the
second,third,and fourth device,as desired.
5. To save the settings and exit the program,press
CBL once.Next,press and hold SETUP until
the CBL key blinks twice,then release SETUP.
To Operate The Master Power Key:
1. After programming,point the remote control
at the devices.Press CBL once.
2. Press MASTER POWER once to sequentially
turn on or off all home entertainment devices.
3. You will see the devices turn on or off
according to the programmed sequence.
To Clear The Master Power Key:
1. Perform steps 1 and 2 in the first section
above, To Program The Master Power Key.
2. To clear the settings and exit the program,
press and hold SETUP until the CBL key blinks
twice,then release SETUP.
Time Warner Houston Manual 11/20/02 3:54 PM Page 14