Filter
Top Products
16
CHANGING VOLUME LOCK
On the URC-1047 Universal Remote Control,Global
Volume Lock is set to TV,so you can control TV volume
while in the TV, VCR,or Cable mode.If desired,you can
still perform Individual Volume Unlock on a selected
device to set its volume control for independent operation.
NOTE:The audio mode’s volume controls are active regardless of
Volume Lock settings. However,if you lock the volume controls to
the AUD mode,you will have control of the audio device’s volume
in all other modes (i.e.,TV,VCR,and CBL).
To Unlock Volume Control For A Single Device
(Individual Volume Unlock):
1. Assuming Global Volume Lock is active,select
a mode on the remote control that you want to
unlock (e.g.,CBL) and press it once.Next,
press and hold SETUP until the device key
blinks twice,then release SETUP.
2. Enter 9- 9 - 3.The last-selected device key
will blink twice.
3. Press VOL– once.The selected device key will
blink four times.
4. Repeat steps 1 through 3 (of this section) for
each device you want volume to be unlocked.
5. Now,after you select a device that has volume
unlocked (e.g.,CBL),pressing VOL+, VOL–,or
MUTE,will control the device’s volume only in
its own mode.
To Unlock All Volume Control
(Global Volume Unlock):
NOTE:Performing these instructions will set independent volume
control for all programmed devices (e.g.,TV volume control in
TV mode,VCR volume in VCR mode,etc.).
1. On the remote control,press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9- 9 - 3. The last-selected device key
will blink twice.
3. Press VOL+ once.The last-selected device key
will blink four times.
Time Warner Houston Manual 11/20/02 3:54 PM Page 16