Filter
Top Products
11
Device Sleeptimer
If your TV or Satellite has a “Sleeptimer” function built in, you can
access this function with your TOTAL CONTROL remote. To do so:
1 Make sure your TV (or Satellite) is switched on.
2 Press the device key (TV or SAT).
3 Point the TOTAL CONTROL at your TV (or Satellite) and
press and release the SET key then press POWER. You should
see the Sleeptimer activate on your TV screen. To increase
the timer, simply press POWER again (within 5 seconds) until
the timer gets to the desired time.
- To deactivate the Sleeptimer, repeat steps 1-3 above. During step 3,
continue pressing Power (within 5 seconds) until the timer indicates
zero minutes.
- Depending on how you used sleeptimer on the original remote, you
might need to access sleeptimer in a different way (through menu for
example).
TOTAL CONTROL Sleeptimer
If your device does not have a sleeptimer function built in, you can
install the TOTAL CONTROL Sleeptimer function. To do so:
1 Press the device key (TV, SAT, CD or AUD).
2 Then, press and hold the SET key until the red light blinks twice.
3 Press 9 7 0. The red light will blink twice again.
- It is only necessary to follow steps 1, 2 and 3 once. For subsequent use
of the ”TOTAL CONTROL sleeptimer”, simlpy follow steps 4, 5, 6 and 7.
- To switch the TOTAL CONTROL back to "Device Sleeptimer", repeat
steps 1, 2 and 3. The red light will blink 4 times.
Setting the TOTAL CONTROL Sleeptimer:
It is possible to set the timer for 15, 30, 45 or 60 minutes.
4 Make sure that your device is switched on.
5 Press the device key (TV, SAT, CD or AUD).
6 Now, press and release the SET key, then press POWER.
The red light will blink once, which indicates the timer
is set for 15 minutes. To increase the timer, simply press
POWER again (this must be done within 5 seconds).
The red light will blink twice indicating the timer is set
for 30 minutes (2 x 15). You can press POWER to a maxi-
mum of four times which will set the timer to 60 minutes.
7 Once you have set the timer to the desired time, set your
TOTAL CONTROL down, pointing it at your device. When
the programmed amount of time has elapsed, the TOTAL
CONTROL will send the command for POWER, hence tur-
ning off your device.
- The red light will blink every 15 seconds indicating that the remote is in
sleeptimer mode.
- To deactivate the Sleeptimer, simply press any key on the TOTAL CONTROL.
- Remember, when using the ”TOTAL CONTROL Sleeptimer”, you must
set the remote so it is pointing at your device.
- The sleeptimer can only be set for only one device at a time.
11
POWER
POWER
POWER
POWER
(:15)
(:45)
(:60)
(:30)