Filter
Top Products
12
The Learning Feature
After you have set up the TOTAL CONTROL for your device, you
may find that there are one or more keys that you had on the original
remote control, which do not have a place on the TOTAL CONTROL
keypad.
The custom keys have been especially provided for this feature. By
using these keys, you will not have to sacrifice an existing function on
the TOTAL CONTROL keypad. If you need to learn more than six
functions per mode (max. approximately 25 functions), you need to
place the learned function on another key (see ”Shifted Learning” on
the next page).
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your TOTAL CONTROL, nor your original
remote control is pointing at your device.
Example: To copy the "mono/stereo" function from your
original TV remote control onto the A-key of your
TOTAL CONTROL.
1 Place the TOTAL CONTROL and your original remote
control on a flat surface. Make sure the ends which you
normally point at your device are facing each other. Keep
the remotes at a distance of 2 to 5 cm.
2 Press and hold the SET key until the red light blinks twice.
The red light will blink once then twice.
3 Press 9 7 5 (the red light blinks twice).
4 Press the device key on the TOTAL CONTROL remote to
select the mode to which you want to copy the learned func-
tion (Example: TV key).
5 Press the key on the TOTAL CONTROL remote where
you want to place the learned function (Example: A key).
The red light will flash rapidly.
6 Press and hold the key (on your original remote control)
that you want to copy until the red light blinks twice
(Example: mono/stereo key).
7 If you want to copy other functions within the same mode,
simply repeat steps 5 and 6 pressing the next key you want to
copy by learning.
8 To exit the learning mode, press and hold the SET key until
the red light blinks twice.
- Learning is mode specific. To access your learned function, press the
appropriate device key first.
12