Filter
Top Products
STEP 5: Once the AVEX R6 has learned all the
buttons in the selected component mode, press and
hold the Component button and SELECT [SEL] but-
tons at the same time to save the learned functions.
The component LED light will blink three times to
confirm the programming. Now test all the buttons
to make sure they learned correctly.
Repeat Steps 1-5 to program any other
component modes.
If the Learning Method does not work,
here are a few suggestions:
• If you have a Plasma TV, move to another room
• Avoid programming under fluorescent light or
direct sunlight
• Put new batteries in the old remote
• Gradually vary the distance between the
two remote controls
• Tap the button on your old remote instead
of pressing and holding it during the
learning process
Here are some additional facts regarding
the Learning process:
• Learned functions override any existing
pre-programmed functions on the remote control
• Learned functions are automatically erased when
a new function is learned on the same button
• Learned functions are retained even after a
different set-up code number is programmed
into the remote control
• To return to an original pre-programmed function,
a learned function must to be erased
Page 15