Filter
Top Products
Page 26
Erasing Commands --
Overview
You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
STEP 1: Press the component button where the
learned command is stored and the ENTER buttons
at the same time for two seconds until the compo-
nent LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will have
to start over.
COMPONENT
BUTTONS
ENTER
STEP 2: Press and hold the button you want to
erase for two seconds. The component LED light
will blink twice to confirm the erasure.
STEP 3: Repeat Step 2 to erase any other buttons
in the selected component mode.
STEP 4: To exit Erase mode, press and hold both
the component button and the ENTER (ENT) button
at the same time until the component LED light
blinks three times.