Filter
Top Products
Page 27
Erasing All Learned Commands from
One Component
This function allows you to erase all the learned
commands from one component. For example, if
you want to erase all learned commands on the TV
component button because you bought a new TV,
the process is very simple.
STEP 1: Press the component button where all the
learned commands are stored and the ENTER button
at the same time for 2 seconds until the component
LED turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press and hold both the component button
you want to erase and the PAUSE button at the
same time for two seconds, until the component
LED light blinks twice to confirm the erasure.
COMPONENT
BUTTONS
PAUSE
ENTER
STEP 3: To exit Erase mode, press and hold both
the component button and the ENTER (ENT) button
at the same time until the component LED light blinks
three times.