Filter
Top Products
Installation
28 Vidikron PlasmaView VHD Installation/Operation Manual
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the VHD Controller; see
Figure 3-10.
For more information about using this connection, refer to Serial Communications on
page 55.
Figure 3-10. RS-232 Control System Connection
Connecting 12-Volt Trigger
Outputs to External
Equipment
If your home theater contains equipment that responds to 12-Volt triggers, connect it to the
12-Volt trigger outputs as shown in
Figure 3-11.
Figure 3-11. Connecting 12-Volt Trigger Outputs
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
to 12-Volt
trigger-activated
equipment
3.5-mm
mini plug
Tip = +12V
Sleeve = Ground