Filter
Top Products
Controls and Functions
8 Vidikron PlasmaView VHD Installation/Operation Manual
PRE
L
IMINAR
Y
1. SLOT 1
Not used.
2. SLOT 2 (Dual HDMI input)
HDCP-compliant digital video inputs. Connect the HDMI output from the VHD
Controller to input “A” in this slot.
3. PC IN
Not used.
4. RS-232C (9-pin, male D-Sub)
Connect the RS-232 OUT port on the VHD Controller to this input.
5. POWER INPUT
Connect the PlasmaView VHD to AC power here.
2.2
VHD Controller Front
Panel
Figure 2-5 shows the controls and indicators on the VHD Controller front panel; the
paragraphs that follow describe them.
Figure 2-5. VHD Controller Front Panel
1. POWER BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to standby
mode. For a discrete on or off command, you can use the direct access buttons on the
remote control.
2. IR SENSOR
Receives IR commands from the remote.
3. VACUUM FLUORESCENT DISPLAY
Can be used instead of the On-Screen Display (OSD). Displays currently-selected menu
or – if no menu is selected – the current source, signal format (NTSC or PAL), input
resolution and aspect ratio.
Component SD NTSC 480i
16:9 VP-VHD
1 2 3