Filter
Top Products
Vidikron PlasmaView VHD Installation/Operation Manual 33
PRE
L
IMINAR
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Press the main power switch at the front of the PlasmaView VHD (see Figure 2-1). The
standby/on indicator lights green.
3. Set the main power switch at the rear of the VHD Controller (see Figure 2-6) to the “on”
position.
4. Press the ON button on the remote control to turn
on the VHD Controller and PlasmaView VHD (or
press the power button on the front of the VHD
Controller). The power indicator on the VHD
Controller lights solid blue.
5. After a brief warm-up period (approximately 10
seconds), the PlasmaView VHD will display an
image.
4.2
Setting the Computer
Display Properties
To maximize image quality when using the PlasmaView VHD with a personal computer, you
may need to adjust the display properties of your computer’s video card. To do this on a
Microsoft® Windows®-based PC:
1. Choose Settings from the Windows Start
Menu and click on “Control Panel.”
4Operation
LIGHT
OFF
ON