Filter
Top Products
ViewSonic PJ751
25
Input Menu
With the INPUT menu, the four items shown in the Table below can
be performed. With inputting of RGB IN 1 and RGB IN 2 signals, the
horizontal and vertical frequencies of the signals will be displayed on
the initial screen of the INPUT menu.
Perform each operation according to the instructions in the Table.
Item Description
AUTO Auto Adjust (for RGB): Automatically adjusts H POSITION, V POSITION, H PHASE, and
H SIZE. Use this function with the maximum window size.
Auto Adjust (for VIDEO/S-VIDEO): Automatically selects the proper VIDEO mode for the
current input signal. This function is active only when the AUTO mode is selected for the
item VIDEO. Refer to the description for the item VIDEO below.
This function may not be available with a PAL60 signal and certain other signals.
The AUTO mode operation requires approximately 10 seconds.
For COMPONENT VIDEO, the signal type is identified automatically even if this function
is inactive. For a HDTV signal, refer to the item HDTV below.
VIDEO Select Mode of Signal Type (for VIDEO/S-VIDEO):
AUTO NTSC PAL SECAM
NTSC4.43 M-PAL N-PAL
Selecting AUTO mode activates and performs the AUTO function for VIDEO/SVIDEO. It
automatically selects the proper mode from among those above. Use this function if the
image becomes unstable with VIDEO/S-VIDEO. (e.g. The image becomes irregular, or
lacks color.)
AUTO mode may not function correctly with a PAL60 signal and certain other signals.
The AUTO mode operation requires approximately 10 seconds.
For COMPONENT VIDEO, the signal type is identified automatically even if this function
is inactive. For a HDTV signal, refer to the item HDTV below.
HDTV Select HDTV Signal Mode:
1080i 1035i
If the selected HDTV mode is incompatible with the input signal, the picture may be dis-
torted.
SYNC ON G On/Off SYNC ON G Mode:
TURN ON TURN OFF
Selecting TURN ON turns on the SYNC ON G mode. The SYNC ON G mode allows
reception of SYNC on G.
In the SYNC ON G mode, the picture may be distorted with certain input signals. In such
cases, remove the signal connector so that no signal is received and turn SYNC ON G
off, and then reconnect the signal.
Example: INPUT Menu
(AUTO)