Filter
Top Products
6
ViewSonic PJ751
Inserting the Batteries
Insert the AA batteries into the remote control device.
1 Remove the battery cover. Push the knob while lift-
ing the battery compartment cover.
2 Insert the batteries according to their plus and
minus poles.
3 Replace the battery compartment cover.
CAUTION
• Be sure to only use the specified batteries with this
remote control device. Do not mix new and old
batteries, since this may result in a cracking or leakage of batteries posing a risk of fire or leading
to personal injury.
• Insert the batteries into the remote control device according to the indicated plus and minus poles.
An incorrect insertion may result in a cracking or leakage of batteries posing a risk of fire or lead-
ing to environmental pollution.
• Before disposing of the batteries, please be sure to observe the respective regulations concerning
the protection of environment in your country or area.
• Always be sure to keep the batteries out of reach of children or pets.
• If the remote control device will not be used for an extended period of time, remove the batteries
from its battery compartment.
NOTE:
Replace the batteries if the operation of the remote control device becomes irregular or weak.
Attaching the Strap Handle
Attach the enclosed handle, if necessary.
1 Lift up the hook and pass one end of the strap through the hole of the handle hook.
2 Buckle the end of the strap as shown on the right.
3 Fix the other end of the strap to the other handle hook in the same way.
CAUTION
Be sure that the strap is secure befor attempting to lift the projector by its handle. Dropping the pro-
jector may result in damage to the unit or electrical shock.