Filter
Top Products
VIZIO GV47L FHDTV20A User Manual
Version 4/23/2008 33
www.VIZIO.com
Chapter 3 Setting Up to Watch Television
For ‘Preparing Your LCD HDTV for Wall Mounting’, see page 6.
3.1 Basic LCD HDTV Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the LCD HDTV, and then
plug the power cord into an AC wall socket.
2. Connect Audio and Video Cables to the LCD HDTV
(see pages 18 ~ 31 for detailed steps)
3. Turning Po
wer On
Once all the components are connected, press the Power ON button
on the side of the LCD HDTV, or press the Power ON (Red) button
on the remote control.
4. Select Input Source
Select the Input Source for the LCD HDTV by pressing the INPUT
button on the side of the TV or using the Input button on the remote
control. Pressing this button will cycle you through the following
options: TV, AV1, AV2, Component 1, Component 2, RGB, HDMI1,
HDMI2, HDMI3 and HDMI4.
5. Using DTV and TV with an Antenna or Cable
If an antenna or cable source is connected to the DTV/TV input, you will need to select TV using
the INPUT button on the remote control or touch sensor on front right hand side of the LCD HDTV,
or directly by pressing the TV button on the remote control, and Auto Scan for the available TV
channels.
a. The screen will show ‘snow’ and the first
Initial Setup OSD panel.
Press the OK button on the remote
control.
Note: If you do not see this option within the OSD, you might
have selected the wrong input in the previous steps and you will
need to repeat step 4 (above) to select the correct input source.