Filter
Top Products
VIZIO P50 HDTV20A User Manual
Version 12/6/2007 34
www.VIZIO.com
3.2 Watching a TV Program
1. There are 3 options for selecting your programming:
a. If you are using an antenna or cable connected through the DTV/TV CABLE/ANTENNA
input, you can select TV directly by pressing the TV button on the remote, or by pressing
the INPUT button on the remote or on the side of the HDTV.
b. If you are watching broadcasts through a cable or satellite set-top box connected by an
HDMI cable, select HDMI directly by pressing the HDMI button on the remote, or by
pressing the INPUT button on the remote or on the side of the HDTV.
c. If you are watching broadcasts through a cable or satellite set-top box connected by a
Component (YPbPr) cable, select Component directly by pressing the Component button
on the remote, or by pressing the INPUT button on the remote or on the side of the HDTV.
2. When using option 1a, press the Channel buttons on the remote or the CH+ or CH- buttons
on the side of the HDTV to change the channel. Note: The Channel buttons, on the side of
the HDTV and on the remote, control will not work if you are watching a program using HDMI,
Component and AV inputs.
3.3 Adjusting Basic HDTV Settings
Volume
To increase the volume, press and hold the VOL+ or VOL-
button on the side of the Plasma HDTV or remote control until
the desired level is reached.
TV Channels
To step up or down through the available TV channels, press
the CH+ or CH- button on the side of the HDTV or remote
control once for the next or previous channel, or hold it
depressed until the desired channel is reached. Note:
Channel up and down will only operate in DTV and TV modes.
Wide
Using this feature, you can watch video content in different
size modes on the HDTV. Press the WIDE button on the
remote control to switch among the modes.
Fore more information see Section 4.17 - Understanding
Viewing M
odes, on page 59.
Note: You should be able to see a picture. If you do not, make sure that all of the
HDTV connections are secure and you have selected the correct video input
source.