Filter
Top Products
VIZIO VW47L FHDTV10A User Manual
Version 9/18/2007 11
www.VIZIO.com
1.4 VIZIO Remote Control
GUIDE – This button displays program information. Press this button once when in TV mode and the
information of the program being viewed is shown. Press it a second time and the Electronic
Programming Guide will appear in the screen. In any other mode when this button is pressed, the screen
will display the selected input plus the definition of the signal; i.e. HDMI 720p, HDMI 1080i, etc.
POWER – Press this button to turn the TV on from the Standby mode. Press it again to return to the
Standby mode.
HDMI – Press this button to select the HDMI input. By pressing it
repeatedly you will go through the three (HDMI 1, HDMI 2 and HDMI 3)
inputs in sequence.
MUTE – This button turns the sound on and off.
TV – Press this button to select TV.
COMPONENT – Press this button to select the Component (YPbPr)
input. By pressing this button repeatedly you will be switching from
Component 1 to Component 2 and vice versa.
LAST – This button recalls the previously viewed channel. If the On-
Screen Display (OSD) menu is being used, this button will allow you to
get back to previous menu screen or out to your program when you
press it repeatedly.
AV – Press this button to select AV (either Composite or S-Video) input.
MENU – Use this button for the On-Screen Display (OSD) menu. When
it is used within a menu selection, pressing this key will help you to
make the selection of the feature to be adjusted after it has been
highlighted.
-These labeled buttons are used to navigate the OSD
menu. When navigating the OSD menu, the arrows control the direction
up and down or left and right. They will also be used as value settings
when the slide bar is shown on the screen and option settings to turn a
feature off or on.
hen
NUMBER BUTTON PAD – Use these
buttons to select a channel or enter a
password.
INPUT – This button allows the user to cycle
through the inputs. Repeatedly pressing of
this button will step you through the input
sources in the following sequence: TV,
AV/S-VIDEO, Component1, Component2,
RGB, HDMI1, HDMI2, and HDMI3. Once
you have stepped through the entire
sequence, you will return to the beginning.
- (DASH) – When selecting a digital channel
directly use this button for the separation of
main and sub-channels. For example,
channel 28-2 would be selected by the
button sequence 2 8 ENTER 2.