Filter
Top Products
11
Getting Connected
RGB/Component Video HD Outputs
What you will need:
• 1 RGB cable
• A High-Definition TV with RGB or Component (Y, Pb, Pr) video inputs
1. Connect one end of the RGB/Y,Pb,Pr cable to the Y/R, Pb/G, Pr/B
jacks on the DVG-777K’s rear panel
2. Connect the other end of the RGB/Y,Pb,Pr cable to the RGB or Y, Pb, Pr
inputs on a High Definition TV
NOTE: When using the Component output, the DVG-777K must be set to
YPBPR output. See “Changing the Video Output Mode” in the Operations
section of this manual for detailed instructions on setting the DVG-777K to
YPBPR Mode.
VGA output
What you will need:
• 1 VGA Cable
• A TV or video monitor with a VGA input
1. Connect one end of the S-Video cable to the S-Video output on the rear
panel of the DVG-777K
2. Connect the other end of the S-Video cable to an S-Video input jack on a
TV or monitor
NOTE: When using the VGA output, the DVG-777K must be set to VGA
output. See “Changing the Video Output Mode” in the Operations section
of this manual for detailed instructions on setting the DVG-777K to VGA
Mode.
SCART
What you will need:
• 1 SCART cable
• A TV or video monitor with a SCART input
1. Connect one end of the SCART cable to the SCART output on the rear
panel of the DVG-777K
2. Connect the other end of the SCART cable to a SCART input jack on a TV
or monitor
NOTE: When using the SCART output, the DVG-777K must be set to SCART
output. See “Changing the Video Output Mode” in the Operations section
of this manual for detailed instructions on setting the DVG-777K to SCART
Mode.