Filter
Top Products
QUICK START GUIDE
4 800092-02 Rev. A www.wegener.com
Table 3: DB-9 Female GPIO Pinouts
CAUTION: Do not connect RJ-12 directly to phone line. Equipment damage may result.
Front Panel Controls and Indicators
Figure 2 show the iPump 562 front panel controls and describes them in Table 4. The IRD can be
controlled via
Compel Network Control, local terminal, and On-Screen-Display push buttons. Normally,
Compel is the primary method of controlling the IRD, while the other control methods are supplemental.
Figure 2: iPump 562 Front Panel
Table 4: iPump 562 Front Panel Controls
LCD Menu Navigation
Operate the iPump 562 from the front panel using the arrow buttons and the LCD as shown in Figure 2.
Menu screens on the LCD direct you to screens that control various operating functions including:
programming
audio
Front Panel Functions
Programming Setup
1. Use the right or left arrow buttons to navigate to
Prgm:Prog1.
2. To edit, press
Enter.
3. To navigate to
Prog2 or Prog3, use the top and bottom arrow buttons.
4. To change, press
Enter.
Image Pin Input Output Description Pin Input Output Description
1 Alarm Common 6 Alarm Normally Closed
2 Alarm Normally Open 7 Contact Closure Normally Closed
3 Contact Closure Common 8 Contact Closure Normally Open
4 No Connection 9 Ground
5 Contact Closure GPIO Input (Factory Use Only)
LCD screen
bottom arrow button
Enter button
left arrow button
right arrow button
top arrow button
LED
Item Description
LCD Activates automatically by certain status conditions, such as loss of signal.
To manually activate, press the ENTER button.
Arrow buttons Push buttons activates LCD and selects options displayed.
ENTER Push button enters options selected on LCD.