Filter
Top Products
QUICK START GUIDE
6 800092-02 Rev. A www.wegener.com
OSD (On-Screen Display)
Although the iPump 562 is set up at the factory, you can customize its settings to fit your system using
the
OSD and front-panel buttons. With a monitor attached to the iPump 562 through any of the video
output ports of the IRD, you may use the push buttons to navigate through the menus displayed to view
the existing settings, various status, and version fields.
Some of the functions you can perform using the
OSD menus are:
Tune to a carrier
Configure LNB
Monitor signal quality
Set audio/video decoder options
Set subtitling options
Set relays
Set networking options
View version information
OSD Setup
The
OSD information displays white text on a blue background overlying 80% of the video output from
the
iPump 562 server. View the OSD from a monitor connected to any of the video output ports of the
iPump 562 server.
NOTE: From the front panel, press any key to activate the OSD.
OSD Menus
All menus are white text with a blue background. Highlighted items display as black text on a white
background.
Figure 3 is a representation of the OSD Main Menu.
Figure 3: OSD Main Menu
Navigating OSD Menus
Use the arrow and
Enter buttons on the iPump 562’s front panel to navigate and edit the fields on the
OSD menus. Selectable fields allow you to change the whole parameter from pre-determined options.
Editable fields allow you to change each digit of the parameter.
NOTE: Once a field is updated, you must select Activate and Exit on the submenu and then press
Enter to update the value of the field. Before pressing Enter, you may go back to any field and
correct it prior to acceptance.