Filter
Top Products
QUICK START GUIDE
www.wegener.com 800092-02 Rev. A 5
Audio Setup
Use to setup
Audio 1 or Audio 2 as indicated on the rear of the unit chassis.
1. Use the right or left arrow buttons to navigate to
Aud:A01 or Aud:A02
2. To edit, press Enter.
3. To change, press
Enter.
Closed Captioning (CC) Setup
1. Use the right or left arrow buttons to navigate to
Sub:CC1.
2. To edit, press
Enter.
3. To navigate to
Sub:CC2 or Sub:CC3 or Sub:CC4, use the top and bottom arrow buttons.
4. To change, press
Enter.
LED Indications after Power-Up
Upon power up, the IRD initializes all system components and supplies an operational status. A steady
Green LED indicates that it is locked on a carrier and is capable of producing output (Audio/Video/
Data).
If there is some problem with the IRD or the signal it is receiving the LED flashes Red for alarm
conditions or Amber for warning conditions. In general, alarms indicate that the unit cannot produce
output, while Warnings indicate that, although output is being produced, there is a problem that could
require attention. The most common conditions that produce alarms or warnings are listed in
Table 5.
Table 5: iPump 562 Front Panel Status LED Alarm and Warning Indications
Mode LED Status Condition
Alarm
Red blink = 2 No carrier
Red blink = 3 No RF signal
Red blink = 4 In recovery
Red blink = 5 Eb/No alarm
Red blink = 11 Not authorized
Warning
Amber blink = 1 No response from SEC_MICRO
Amber blink = 2 Marginal Eb/No
Amber blink = 4 Selected audio not available
Amber blink = 5 RF too low
Amber blink = 6 RF too high
Amber blink = 7 Application download failed
Normal Green Normal operation