Filter
Top Products
800057-02 Rev. A Page 2 of 11 May 24, 2003
Basic System Setup Diagram
Front-panel User Interface
Note that from any screen, pressing the ESC key twice will return you to the Home Screen.
Main-level Screens Second-level Screens
Home Screen (rotates through data from each of the four RF
inputs)
The channel number, modulation type (8VSB, 64QAM, or
256QAM), signal-to-noise ratio, and errored seconds are
displayed for each input.
Press the 4 key (if displayed) to go to Alarms/Warnings.
Press the ENT key to view the second-level Serial Number
and Application Software Version Number screen.
Serial Number and Application Software Version Number
Screen
Where XXXXXX is the unit's six-digit serial number and YYY is
the version number of the unit's currently installed application
software.
Press the ESC key to go to the Home Screen.
Alarms/Warnings
Press the ENT key to view any active alarms or warnings on
the second-level Alarms/Warnings Message screen.
Press the 4 key to go to Clear Errored Seconds (if counter is
non-zero) or Program Setup.
Press the ESC key to go to the Home Screen.
2
nd
-level Alarms/Warnings Message Screen
Any active alarms or warnings are described here.
Press the 4 key to view the next alarm or warning (if more than
one).
Press the ESC key to return to the Alarms/Warnings screen.
Clear Errored Seconds
This screen only appears if the errored seconds counter is
non-zero. Otherwise the next screen, Program Setup is
displayed.
Press the ENT to clear the errored seconds counter.
Press the 4 key to go to the Input Setup screen.
Press the 3 key to go to Alarms/Warnings.
Press the ESC key to go to the Home Screen.
RF3 CHAN:20 8VSB
SNR21.5 ErrSec:0002
S/N:XXXXXX
V
ER:YYY
V
iew Alarms/Warnings
N
o Alarms or Warnings
Clear Errored Secs
Press<ENT>