800057-02 Rev. A Page 3 of 11 May 24, 2003
Main-level Screens Second-level Screens
2
nd
-level RF Input
Where X is the RF port number.
Press ENT to go to the third-level Input Setup Screens below and
use the 5 or 6keys to select <ON> or <OFF>, adding or
removing this program to/from the output stream. Press ENT
again to confirm.
Press the 4 key to go to the next RF Input screen (1 through 4).
Press the ESC key to return to the Input Setup screen.
3
rd
-level Tuner Enable
Press the ENT key to toggle between ON and OFF, enabling or
disabling the tuner.
Press the 4 key to go to the Channel Number Selection screen.
Press the ESC key to return to the second-level RF Input screen.
3
rd
-level Channel Number Selection
Where XX is the current channel number.
Press ENT to enter the edit mode and use the 5 or 6keys to
change the channel number. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the 4 key to go to the RF Standard screen.
Press the 3 key to go to the Tuner Enable screen.
Press the ESC key to return to the second-level RF Input screen.
Input Setup
Press the ENT key to bring up the second-level Program
Input screen.
Press the 4 key to go to Program Status.
Press the 3 key to go to Clear Errored Seconds (if counter is
non-zero) or Alarms/Warnings.
Press the ESC key to go to the Home Screen.
3
rd
-level RF Standard
Press ENT and use the 5 or 6keys to toggle the RF Standard
between Broadcast and Cable. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the 3 key to go to the Channel Selection screen.
Press the ESC key to return to the second-level RF Input screen.
Input Setup...
RF Input X
Tuner Enable:
Channel Number: XX
RF Standard:
