Filter
Top Products
10
Troubleshooting
The MV3500A does not attempt to nd a satellite or
it never moves.
The dish never stops on any of the signals that
it sees.
1. Check your Power switch to verify that it is in the ON position.
2. Check +12 V wires at unit to verify power. Check fuse on
electronics.
PROBLEM
SOLUTION
1. Make sure that your receiver is set up correctly.
For DISH Network, the check switch should read either “Unknown”
or “SW42”.
For DirecTV the receiver should be set for a Two Satellite Oval
Dish.
With DIRECTV, the dish will nd the alternate
satellite but it never nds the primary satellite.
I am not getting all the DISH Network channels
I subscribed to.
The MV3500A never sees any signals, it just keeps
searching.
Make sure that the Switches on the Electronics Control Box are
set for DirecTV. See page 3. These switches are found under the
dome, inside the Electronics Control Box.
1. Go to the check switch menu in receiver. Make sure that it’s set
for SW42 and lists both even and odd transponders on satellites
110° and 119°.
1. Rain, Snow or excessive Dew on the dome can interrupt the
signal. Snow and Dew can be brushed off the dome. If Heavy rain
or Snow fall is blocking the signal, it may be necessary to wait
until the weather clears.
2. Check to see if the Southern sky is clear. Trees, Buildings,
Large signs or an Overpass can block the signal. Find an area
where you can be sure that this is not the problem and try again.
3. Make sure the receiver has power and the satellite dish is con-
nected to the “Sat In”.