Filter
Top Products
5
All required screws, washers, bolts, and nylocks
1 base with electronics, dish, dual LNBF
30’ Coax Cable
30’ Power/Data Cable bundle
1. Open box and remove packing material.
2. Lift dome out of box vertically. Then lift unit out of box
vertically. Do not turn box and “roll” out, or turn up-
side down to remove.
!
USE 2 PEOPLE
when removing the unit
from the carton.
Parts Included • Tools Needed • How to Unpack
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
1 Radome
1 Power switch
1 Wall plate (white)
1 Surface mount box
1 Cable entry plate
4 Base feet
large yellow ag connector
2 small red ag connectors
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
UNPACKING THE UNIT
Level
Drill w/3/4” bit
1-1/4” hole saw (if mounting switch in wall)
Phillips screw driver #2
3/8” Open end wrench
1/2” Drill bit
7/16” Open end wrench
Sealant (consult RV manufacturer for proper type
for your roof material)
PARTS INCLUDED:
!
BE CAREFUL when
removing unit. Dome is
attached to base by only
3 pieces of tape, NOT BY
SCREWS.
!
DO NOT PAINT DOME!
Painting dome will cause
signal degradation.
REV. 7/07