Filter
Top Products
ROOF ELEVATING SHAFT W/RW-1000 DIRECTIONAL
THICKNESS LENGTH HANDLE LENGTH
4 3/4" 6 1/4" RP-4200 req. 5 3/8"
4 1/2" 6" RP-4200 req. 5"
4 1/4" 5 3/4" 6 1/4" 4 3/4"
4" 5 1/2" 6" 4 1/2"
3 3/4" 5 1/4" 5 3/4" 4 1/4"
3 1/2" 5" 5 1/2" 4"
3 1/4" 4 3/4" 5 1/4" 3 9/16"
3" 4 1/2" 5" 3 3/8"
2 3/4" 4 1/4" 4 3/4" 3 1/16"
2 1/2" 4" 4 1/2" 2 3/4"
2 1/4" 3 3/4" 4 1/4" 2 3/8"
2" 3 1/2" 4" 2 1/16"
1 3/4" 3 1/4" 3 3/4" 1 3/4"
1 1/2" 3" 3 1/2" 1 3/8"
1 1/4" 2 3/4" 3" 1"
STEP 5. The mount is designed to fit roofs 1" to 4 3/4" thick. If roof is less
than 4 3/4" thick, cut elevating shft and directional handle to size. (See table
below.) If roof is more than 4 3/4" thick, the RP-2000 Thick Roof Kit
is required. See page 15, A for chart.
CAUTION: IF YOU ARE USING THE RW-1000 ROOF WEDGE,
ADD 1/2" TO ELEVATING SHAFT LENGTH GIVEN BELOW, BUT NOT
TO THE DIRECTIONAL HANDLE.
STEP 6. Mount antenna and lift on roof in travel position. Apply approved
sealing compound suitable for your vehicle roof on bottom of base plate and
roof area around hole. See Figure 3. Secure base plate with screws provided,
except for screw indicated in Figure 3*.
STEP 7. Attach cable clamp to the coax cables 16" from the cable clamp
on the gear housing.
STEP 8. Attach cable clamp to roof of RV as shown in Figure 3, use 7/16"
flat washer between screw and cable clamp, apply sealing compound over
mounting screw heads.
STEP 9. Attach satellite antenna coax cable (has "RG-6" printed on it)
to the coax cable going to the satellite receiver.
STEP 10. Attach RS-1000 coax downlead (has "RG-59" printed on it)
to coax downlead going to RV-0541 power supply. Refer to power supply
instruction sheet. You can connect the antenna output from the power
supply directly to the satellite receiver (refer to receiver manual). This
allows you to watch local channels when you turn the receiver off.
Rev 1/2001
Direc-
tional
Handle
4