Filter
Top Products
STEP 11. Feed downleads through roof using Winegard Model CE-2000
cover plate (included with hardware). Weatherproof cable entry by
applying approved sealant under lip of roof-thru plate and where cable
enters roof. Attach plate to roof with screws provided. Apply approved
sealant over screws and around edge of roof-thru plate, making sure cable
entry is sealed. Secure cables as necessary to prevent whipping. Use
tie-wraps provided to secure cables together.
STEP 12. Connect satellite coax downlead to satellite receiver, refer to
receiver manual on proper connections. If coax connections are made
outside the coach YOU MUST WEATHERPROOF THE CONNECTIONS!
STEP 13. Assemble ceiling plate, directional handle and crank handle as
shown in Figure 4. The circled numbers indicate placement from the
ceiling down. Example: The ceiling plate 1 is located next to the ceiling.
The elevation crank handle 8 is farthest from the ceiling. The number
also indicates sequence of assembly.
CAUTION: USE CAUTION WHEN INSTALLING THE ELEVATING
CRANK. ONCE SCREW TOUCHES SHAFT, TIGHTEN ONLY 1/4
TURN MORE. SCREW SIMPLY HOLDS ELEVATING CRANK ON.
DO NOT OVERTIGHTEN!
CAUTION: DO NOT GET SEALING COMPOUND
ON BEARING SURFACE BETWEEN BASE PLATE
AND ROTATING GEAR HOUSING. DO NOT PAINT
TOP OF BASE PLATE OR AROUND ROTATING
GEAR HOUSING.
NOTE: Apply sealant approved for
your vehicle roof between Base Plate
and roof of vehicle.
3" min.
Cable clamp on gear housing.
INSIDE RV
Attach cable clamp here. Make sure there are
16" of coax between the cable clamp on the gear
housing and the one here 3" in front of base
plate. TOO MUCH OR TOO LITTLE WILL CAUSE
DAMAGE TO COAX.
FIGURE 3
Cable Ties
#10 x 1" Screws
Apply approved sealant
under lip and cable roof
hole
Make sure cable
entry is sealed
5