Filter
Top Products
10
11
THE LEARNING KEY
Your PVR remote has four learning keys plus a self-coding funcon. The keys can be used for
the STB remote to funcon as any of the four keys on your TV remote.
The recommended keys to use are “TV POWER”, the two grey keys below “TV POWER” ”TV/
AV”, and “SET”. The idencaon of ”TV/AV” key varies with the TV type. For example,
idenfying AV INPUT 1 2 3, etc.
You do not need to use your TV remote when watching the digital TV program and services
once your PVR remote has been set up to turn on your TV and change to the correct AV
channel.
Press and hold the “SET” key on your remote for three seconds, indicator light will keep on;1.
Aim your TV remote to the “receiving window” on the back of your PVR remote while 2.
pressing the key you want it to learn (eg. the Power buon on your TV remote).
The indicator light of the STB RCU ashes three mes, and it indicates that the STB RCU has 3.
received the signal from your TV remote;
And press corresponding learning key on “TV key” window of your PVR remote again (such 4.
as the TV power key), the indicator light will ash three mes. This indicates that the key
has been learnt successfully and is ready to use.
When pressing keys on the “TV key” secon on your PVR remote, the indicator light will 5.
ash. This indicates that your PVR remote is sending control signals to your TV. It is the
same as the VOL+, VOL- and TV/AV keys.
APPENDIX:
When watching TV pressing the “INFO” key on your remote will bring up the informaon of 1.
the current and next program, such as name, starng me and ending me. This message
will disappear automacally aer several seconds.
The descripon informaon of the current channel will be displayed on the screen for 2.
several seconds by pressing the “INFO” buon again.
4. CONNECTION DIAGRAM
There are various ways to connect your PVR to your TV.
The recommended opons to obtain high denion picture is via HDMI, followed by
Component (YPbPr).
A. USING HDMI CABLE
HDMI is the recommended connecon for your PVR (if you have a TV with an HDMI input). An
HDMI connecon will allow you to transmit 1080i digital video and digital audio signals using a
single lead.
Connect the antenna to ANT IN of the STB•
Connect one end of your HDMI lead to the PVR and the other end to the HDMI port on •
your TV.