Woods Equipment BH6000 TV Mount User Manual


 
26 Assembly
MAN0306 (Rev. 5/23/2008)
ASSEMBLY
GENERAL ASSEMBLY INSTRUCTIONS
Backhoe assembly is the responsibility of the WOODS
dealer. The backhoe should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal operating conditions.
Set backhoe up as received from the factory with these
instructions and illustrations.
The backhoe must only be mounted with a Woods sub-
frame kit.
When mounting this backhoe on a tractor using a sub-
frame mounting, special assembly instructions (which
are contained in another manual furnished with the
sub-frame) apply to some of the assembly procedures.
The backhoe is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware.
Recommended torque values for hardware are given
on page 41.
NOTE: References to right, left, forward and rearward
directions are determined from the backhoe operator
seat position facing rearward.
Figure 18. Backhoe Directions
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
INSTALL STABILIZER
Remove stabilizer arms from pallet.
Remove pivot pins (3 & 4) from their shipping position.
Attach stabilizer arm (1) to main frame (8) using pivot
pin (4) and secure with bolt (7) and locknut (6).
Attach stabilizer cylinder (2) to stabilizer arm with pivot
pin (3) and secure with cotter pins (5).
Figure 19. Stabilizer Arm Assembly
CAUTION
1. Stabilizer arm
2. Hydraulic cylinder
3. 1.0 x 4.40 Pin
4. 6.73 Pin
5. 3/16 x 1-1/2 Cotter pin
6. 3/8 NC Lock nut
7. 3/8 NC x 1 Carriage bolt
8. Main frame