Filter
Top Products
Basic Configuration DRS5116
Wren
2003. 09. 06 (v 1.0)
101
DHCP can also be used for xDSL (PPPoE) interface. Sometimes, all computers on a Local Area
Network (LAN) share a single Floating / Dynamic IP address. In this case, the DRS should be assigned
a private IP address and have the DHCP enabled. Users on the LAN can connect to the DRS using the
private IP address and outside users can connect to the DRS over the Internet.
IP Address, NetMask, and Gateway Address, DNS
The administrator may configure IP address, subnet mask, gateway address, and DNS addresses of the
DRS.
16.8.6.2. xDSL
If the DRS is connected on xDSL line and needs PPPoE process, the network administrator should
configure the user ID and password for PPPoE. ID. The password may be acquired from the ISP
that installed the line. Once configured, the DRS will receive an IP address when it is connected on
xDSL line.
User ID/Password
When the DRS is connected to xDSL, the access ID and Password should be entered.
Status
This function displays the DRS connection status.