Filter
Top Products
4
URC-2
b) If you allow more than 30 seconds to elapse between key presses, the URC-2 will automatically
leave the Program Mode (enters Sleep Mode).
If this occurs, simply repeat steps 3 through 5.
6. Pick another key and repeat steps 4 and 5 for all commands you wish the URC-2 to learn.
7. When finished, press CANCEL and the active Source Key
simultaneously to leave the Program Mode
(or allow it to time out by waiting 30 seconds). Refer to Fig. 7.
You may now test the newly learned commands by pressing the keys
you programmed.
When you press a key with a stored command, the active Source LED
will blink indicating transmission of the command. No blinking will occur
when keys are pressed that do not have commands.
Deleting Commands
If a command does not work, or you wish to change a command for any
reason, proceed as follows:
8. Simply repeat steps 4 and 5. This will "write over" the original
command, replacing it with the new.
If you wish to delete a command from a key or from a number of keys,
proceed as follows:
9. Press DEL and a Source Key
simultaneously. This puts you in the
Delete Mode. The Status LED will blink Red.
10. Press the key you wish to delete.
The Status LED will blink Amber briefly, indicating the command
was deleted, then blink Red, waiting for your choice of another key.
11. Repeat step 10 for all keys you wish to delete.
12. When finished, press CANCEL and the active Source Key
simultaneously to leave the Delete Mode
(or allow it to time out by waiting 30 seconds).
PROGRAMMING SEQUENCES (Macros)
You can teach more than one IR command per key by using the Sequence Programming feature. This
permits several commands to be executed by one key press to carry out a macro of several system
functions. To teach a sequence of commands to a single key, do the following:
1. Press SEQ and a Source Key
simultaneously. This puts you in the Sequence Mode. The Status LED
will blink Green.
2. Now press the desired target key just as when doing regular IR programming (if a different Source
key, press twice; if a Function key, press once).
The Status LED will be a steady Green, indicating that it is ready for IR input.
3. Press briefly the desired key on the "Teaching" Remote.
The URC-2 Status LED will blink Amber briefly, indicating the command was learned, then go steady
Green, waiting for you to input another command in the sequence.
NOTES:
a) If the Status LED blinks Red twice, then steady Green, an error has occurred and the command
has not been learned. When this happens, simply repeat step 3, but this time vary the distance and/
or the length of time you press the key on the "Teaching" Remote.
1
2
3
URC-2
TV VCR SAT CBL
DVD TNR CD AUX
POWER
T/V
ENTER
VOL
VOL
CH
CH
PR.CH
MUTE
456
7
89
0
PAUSE
STOP
REW FF
INFOEXIT
SEL
PLAY
MENUGUIDE
ABCD
Status LED
will go off
Press and
Release the
CANCEL Key
and the active
Source Key
simultaneously
to leave the
Program Mode
PGM CANCEL DEL XFER
SEQ DELAY EDIT STEP
Fig. 7