Filter
Top Products
7
Controllers
URC-2
9. When stored, the Status LED will flash Amber, then go Green. You
may now STEP to the next command.
NOTE: You do not have to delete anything to add a new command
to the sequence.
Inserting a Delay
A delay may also be inserted in a similar manner.
10. Step through the sequence to a place just ahead of the command
where you wish to insert a delay.
11. Press the DELAY key. The Source LED will blink Amber.
12. Enter the desired delay time (see Programming Delays, step 3).
13. Press CANCEL once to exit Delay Mode. The Source LED will turn
Green, indicating the delay is now stored. You may now STEP
through the remaining commands in the same manner until done.
NOTE: If you wish to step through the sequence again for further
checks and editing, simply press CANCEL, then the target key, then
the STEP key.
When you have finished editing, exit the EDIT Mode completely by
pressing CANCEL once, then CANCEL
and the active Source Key simultaneously. The Status LED
will go out. Refer to Fig. 11.
Restore
In rare instances, while programming the URC-2, or cloning from one to another, the unit may lock up and
not respond to any key presses. If this occurs, temporarily remove one battery, then reinstall it. This
will reset the unit and restore operation. No user programming will be lost.
Clearing all Memory
If, for any reason, you wish to clear all programming from
the unit, press the PGM and the SEQ keys simulta-
neously, then release. Within 1 second, simultaneously
press the DEL and EDIT keys and release. Refer to Fig.
12. The active Source (bank) LED will blink once to
confirm the action.
• Bear in mind that all previous programming will be
lost!
• You may now proceed to reprogram the URC-2 from
scratch.
1
2
3
URC-2
TV VCR SAT CBL
DVD TNR CD AUX
POWER
T/V
ENTER
VOL
VOL
CH
CH
PR.CH
MUTE
456
7
89
0
PAUSE
STOP
REW FF
INFOEXIT
SEL
PLAY
MENUGUIDE
ABCD
The Active
Source LED
will go
Off and On
to confirm
memory clear
PGM CANCEL DEL XFER
SEQ DELAY EDIT STEP
TO CLEAR
ALL MEMORY
2
Within 1 Second
Press
DEL and EDIT
simultaneously,
then release
1
Press
PGM and SEQ
simultaneously,
then release
Fig. 12
Fig. 11
1
2
3
URC-2
TV VCR SAT CBL
DVD TNR CD AUX
POWER
T/V
ENTER
VOL
VOL
CH
CH
PR.CH
MUTE
456
7
89
0
PAUSE
STOP
REW FF
INFOEXIT
SEL
PLAY
MENUGUIDE
ABCD
Status LED
will go off
Press CANCEL
once, then
Press and
Release the
CANCEL Key
and the active
Source Key
simultaneously
to leave the
EDIT Mode
PGM CANCEL DEL XFER
SEQ DELAY EDIT STEP