Filter
Top Products
24
Changing the driver set-
ting (MIDI Patch Screen)
You can change the assignment of I/O connectors on the UX256 and port numbers
selected from the computer.
Sequence software transmits and receives MIDI signals to and from the UX256 via the
driver (page 13). The UX256 is equipped with six MIDI IN/OUT terminals and two TO
TG terminals. You specify the I/O ports of the UX256 to control from the computer’s
sequence software. At this time, changing the driver setting enables you to change
these I/O assignments without re-patching the cables.
For example, you can transmit an identical MIDI signal to multiple ports or transmit
layered MIDI signals from multiple ports to a single port. Also, you can directly route
MIDI signals from MIDI IN to MIDI OUT.
The following table shows the assignment of the port numbers and I/O ports. With the
default settings, the port number matches the computer’s port number.
If a tone generator connected to the TO TG port does not support multi-port
specifications, the selection of ports B-E will be ignored.
port number MIDI output port MIDI input port
Port 1 MIDI OUT1 MIDI IN1
Port 2 MIDI OUT2 MIDI IN2
Port 3 MIDI OUT3 MIDI IN3
Port 4 MIDI OUT4 MIDI IN4
Port 5 MIDI OUT5 MIDI IN5
Port 6 MIDI OUT6 MIDI IN6
Port 7 TO TG1 -A TO TG1
Port 8 TO TG1 -B TO TG2
Port 9 TO TG1 -C
–
Port 10 TO TG1 -D
–
Port 11 TO TG1 -E
–
Port 12 TO TG2 -A
–
Port 13 TO TG2 -B
–
Port 14 TO TG2 -C
–
Port 15 TO TG2 -D
–
Port 16 TO TG2 -E
–
NOTE