83
N Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 5 6 7 8
10
9
TROUBLESHOOTING
Problem:
The Setup Assistant cannot connect my Router to the Internet.
Solution:
If the Setup Assistant is not able to connect the Router to the Internet,
please check the following items:
1. Use the troubleshooting suggestions within the Setup Assistant. If
the troubleshooting screen does not open automatically, click on the
“Troubleshoot” button in the lower, right-hand corner of the Setup
Assistant window.
2. If your ISP requires a user name and password, make sure that you
have typed in your user name and password correctly. Some user
names require that the ISP’s domain be at the end of the name.
Example: “myname@myisp.com”. The “@myisp.com” part of the user
name may need to be typed as well as your user name.
If you continue to have no Internet connection, reference the section
titled “Manually Configuring Network Settings” (page 74 of this User
Manual) for alternate setup method.
Problem:
• The Setup Assistant completed installation, but my web browser
doesn’t work.
• I am unable to connect to the Internet. The Router’s “Internet” light
is off and the “Modem” light is blinking.
Solution:
If you cannot connect to the Internet, the “Internet” light is off, and the
“Modem” light is blinking, the problem may be that your modem and
Router are not connected properly.
1. Make sure the network cable between the modem and the Router is
connected. We strongly recommend using the cable that was supplied
with your cable or DSL modem for this purpose. The cable should be
connected at one end to the Router’s “Modem” port, and at the other
end to the network port on your modem.
2. Unplug the cable or DSL modem from its power source for three
minutes. After three minutes, plug the modem back into its power
source. This may force the modem to properly recognize the Router.
3. Unplug the power to your Router, wait 10 seconds, and then reconnect
the power. This will cause the Router to reattempt communication with
the modem.
If the “Modem” light on the Router is not lit after completing these steps,
please contact Belkin Technical Support.
4. Try shutting down and restarting your computer.
