4
4-5 General Setup options
Enable Printed Queue—Specify whether to enable the Printed Queue, a storage
location on the ColorPASS disk for recently printed jobs. You can reprint jobs from
the Printed queue without sending them to the ColorPASS again. If the Printed queue
is not enabled, jobs are deleted from the ColorPASS disk immediately after they are
printed.
Jobs Saved in Printed Queue—Specify the number of jobs to be stored in the Printed
Queue. Jobs in the Printed queue take up space on the ColorPASS hard disk.
Character Set—Specify whether the Control Panel and the job management tools
should use the Macintosh, DOS, or Windows character set for displaying filenames.
This is important if a filename includes accented or composite characters (such as é
or æ). For mixed-platform networks, select the setting that gives the best overall
representation of the special characters you use.
Start Page—Specify whether the ColorPASS should print a start page when it is turned
on or rebooted. The Start Page displays information about the ColorPASS, including
server name, the current date and time, amount of memory installed, last calibration
date, network protocols enabled, and print connections published.
Support—Enter names, phone numbers, and e-mail addresses of contact people at
your organization who provide support for the ColorPASS and the copier. In remote
Setup, use the Support tab.
Passwords
You can set, change, and remove passwords for the ColorPASS. These passwords,
specific to the Server process, are used for different functions from the Windows NT
Administrator and Operator passwords. Keep careful track of the passwords you set for
each.
Administrator—Controls access to Setup; Administrator privileges also include
Operator privileges.
Operator—Controls access to job management functions via the job management
tools.
NOTE: For more information on ColorPASS passwords and the access privileges they
allow, see page 2-3.
