4
4-9 Network Setup
Ethernet (Port Setup)
Enable Ethernet—Select if the ColorPASS is to be connected to an Ethernet network.
Transmission Speed—Select Auto Detect if your network environment is mixed, or
select the speed (10 Mbps or 100 Mbps) of the network to which the ColorPASS is
attached.
Token Ring (Port Setup)
Enable Token Ring—Select if the ColorPASS is connected to a Token Ring network.
Maximum Frame Size—Select the maximum frame size recommended by the network
administrator at your site. If you are uncertain of the setting to use, select the default
value (4202).
Transmission Speed—Select Auto Sense if your network environment is mixed, or
select the speed (4 Mbps or 16 Mbps) of the network to which the ColorPASS is
attached.
Enable Source Routing—Select if your network supports source routing.
Request All Routes—This option is active only if you enabled Source Routing. Select if
you want the Request packet to travel to its destination by all routes.
Respond All Routes—This option is available only if the previous option is not
selected. Select if you want the Response packet to return by all routes to the
originating computer.
