A SERVICE OF

logo

12 MG302-EU-EN V2.0 4/11
DISPLAY BACKLIGHT
Press the
key to switch the backlight on. The backlight will automatically switch off after the SET
time has expired. Press the EXIT button to exit the backlight on mode.
HOLD
The hold function freezes the reading in the display. Press the HOLD key momentarily to activate or
to exit the HOLD function.
PEAK HOLD
The Peak Hold function captures the peak AC or DC voltage or current. The meter can capture
negative or positive readings as fast as 1 millisecond in duration. Momentarily press the PEAK
button, “PEAK” and “MAX” will display in the left auxiliary display. MIN” will display in right auxiliary
display. The meter will update the dispay each time a greater value occurs. Press the EXIT button
to exit the PEAK HOLD mode. Auto Power Off feature will be disabled automatically in this mode.
DATA STORAGE
1. Set the function switch to the measurement function desired.
2. Press the STORE button to access the recording interval time set up function.
3. The auxiliary display on the left indicates 0000 S, which is the recording sample rate; use the +
& - buttons to select the desired sample rate (0 to 255 seconds)
4. Set the sample rate to 0000 S for manual recording. In this mode, each press of the STORE
button will save one measurement reading.
5. Set the sample rate (from 1 to 255 S) for automatic recording. In this mode, pressing the
STORE button will start data recording at the programmed sample rate.
6. The auxiliary display on the left indicates the current storage location (0000 to 9999). New
measurements will begin storing into the next available location.
7. Press and hold the STORE button for 2 seconds to enter the RECALL mode or press EXIT to
return to the normal operating mode.
DATA STORAGE RECALL
1. Press and hold the STORE button for two seconds (if not already done as instructed in step 7
in the above procedure) to enter the RECALL function.
2. The auxiliary display on the left will show XXXX (current storage location). The auxiliary display
on the right will show XXXX (number of storage locations used).
3. Use the + and - buttons to navigate the storage locations. The value for the selected location is
indicated in the main display.
4. Press the EXIT button to end the recall session.
CLEAR ALL DATA
1. From the OFF position, press and hold the RANGE button while turning the function switch to
any on position
2. Release the RANGE button. The memory has been cleared.