125
Model D2424 Reference Manual (Changing the Initial Settings <SETUP mode>)
Setup of the reference level (“Ref. Level?” menu)
The reference level of D2424 can be changed in the "Setup of the reference level" menu.
At the initial setting, the reference level is set to "-12dB" but can be set to "-20dB" as required. Because the
setup content is registered in the D2424 internal System ROM, it will be held even when the current drive E-
IDE hard disk is replaced.
• Initial setting: [-12dB]
• Options: [-12dB] or [-20dB]
* This setting is shared by all Programs in the same disk.
* The settings cannot be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
1.While the recorder is stopped, press the [SETUP]
key to enter SETUP mode.
2.Turn the [JOG] dial to select “Ref. Level?” (“?”
flashes), then press the [EXECUTE/YES] key.
A flashing “?” will extinguish by pressing the [EXECUTE/
YES] key and the reference level information that was
lit will being flashing. Initial setting, it will show “-12dB”.
Setting the reference level
Flashing
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
2322
21
20
19
18
17
1615141312
11
10
98765
4
3
2
1
CLOCK
INT
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
2322
21
20
19
18
17
1615141312
11
10
98765
4
3
2
1
CLOCK
INT
3. Select the desired reference level with the [JOG]
dial, then press the [EXECUTE/YES] key again.
The selected reference level will be registered and "?"
in Step-2 will return to flashing.
4. Exit from the SETUP mode by pressing the [EXIT/
NO] key (or [STOP] button).
To cancel the operation, or to restore the setting
obtained prior to the [EXECUTE/YES] key press, press
the [STOP] button or the [EXIT/NO] key. Each time
you press one of these keys, the recorder returns to
the previous hierarchy level of the menu, and finally
exits SETUP mode and displays the previous Time Base.
∞
42
OL
0
30
24
18
12
9
6
3
3
2
1
∞
40
OL
0
30
25
20
15
9
6
3
3
2
1
In accordance to the reference level setting, the level
figures will light up in the D2424 display as shown
below.
<At the -12dB setting>
<At the -20dB setting>
