130
Model D2424 Reference Manual (Changing the Initial Setting <SETUP mode>)
Flashing
Setup of the display contrast level (“Contrast ?” menu)
The contrast level of the D2424 display can be setup.
Because this setup content will be registered in the D2424 internal System ROM, it will be held even though
the current drive hard disk is replaced.
1.While the recorder is stopped, press the [SETUP]
key to enter SETUP mode.
2.Turn the [JOG] dial to select “Contrast ?” (“?”
flashes), then press the [EXECUTE/YES] key.
The display will change as shown below and the currently
setup contrast level will be displayed (Initial setting is
“06”).
The flashing “?” will disappear when the [EXECUTE/YES]
key is pressed and the currently set figure will flash.
• Initial setting : Level “6”
* Range which can be setup : Level “0” - Level “12” (Can be set in one step increments.)
* Setup content can be saved/loaded as song data.
3. Select the desired contrast level by rotating the
[JOG] dial, then press the [EXECUTE/YES] key.
The contrast level can be selected in the 0-12 range.
After selecting, the selected drive will be setup by
pressing the [EXECUTE/YES] key.
4. Exit from the SETUP mode by pressing the [EXIT/
NO] key (or [STOP] button).
To cancel the operation, or to restore the setting
obtained prior to the [EXECUTE/YES] key press, press
the [STOP] button or the [EXIT/NO] key. Each time
you press one of these keys, the recorder returns to
the previous hierarchy level of the menu, and finally
exits SETUP mode and displays the previous Time Base.
Setting the contrast level
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
2322
21
20
19
18
17
1615141312
11
10
98765
4
3
2
1
CLOCK
INT
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
2322
21
20
19
18
17
1615141312
11
10
98765
4
3
2
1
CLOCK
INT
