A SERVICE OF

logo

Open as PDF
next previous
●
9-5
■
Reading Mode Setting When the VIDEO INTERFACE BOARD is Installed
This section describes the button specifications and setup details for reading modes when the scanner has
the VIDEO INTERFACE BOARD in the third party slot.
When the reading mode is set by the command from the host computer, the following button operation is
not required.
NOTICE
When the VIDEO INTERFACE BOARD is installed in the scanner, the scanner automatically recognizes
the board and changes the display.
Whenever you press , the scanner returns to screen M1.
1. Turn the power On and verify that “Scanner Ready” is displayed on the LCD.
Screen M1
2. Press then the scanner displays Screen M2.
Screen M2
3. Press then the scanner displays Screen 1.
Screen 1
4. Select ADF or FB by pressing or then press . The scanner displays Screen 2.
Screen 2
5. Select “Simplex” or “Duplex” by pressing or . Then press Enter. The scanner displays
Screen 3.
Screen 3