Removing and installing componen ts
during servicing
Preparing to remove components
If you are going to remove or change system components, prepare for the remo val as follows:
Please observe the safety information in chapter "Important notes", Page 14.
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remove the battery (see "
Removing a battery", Page 54 ).
Installing and removing memory expansion
MemorymoduleMainmemoryRemovingmemorySystemexpansionSystemexpansion
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter "Important notes", Page 14.
When installing/removing mem ory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "
Preparing to remove compo nents", Page 90.
Only use memory expansion modules that have been approved for your
notebook (see "
Technical data", Pag e 107).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the m emory extension compartment.
You must open the service compart
ment to remove o r install a memory module. On some devices,
opening the compartment may exp
ose other components. These components should be removed
and replaced only by authorise
d specialists. Therefore, be sure to observe the following:
Individual components can be
come very hot during operation. Therefore, we
recommend that you wait one ho
ur after switching off the notebook before removing
or installing memory module
s. O therwise, there is a risk of suffering burns!
As some components are expose
d that are sensitive to s tatic electricity, please take
note of chapter "
Notes on ins
talling and removing boards and components", Page 89.
90 Fujitsu Technology Solutions
