A SERVICE OF

logo

Open as PDF
next previous
HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification
Wakeup Commands
Issue 01 (2011-08-26)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
129
Bit [3-7]
Bit[2]
Bit[1]
Bit[0]
Reserved
UART
(Not Supported)
USB
WAKUP_OU
T
Pin
Default Value
3 (Support WAKEUP_OUT Pin+USB)
1: Support WAKUP_OUT Pin only
2: Support USB only
3: Support WAKUP_OUT pin and USB
<source> Parameter to configure remote wakeup source with length of 2 bytes.
This parameter is defined with 16-bit mask. Every single bit represents a remote
wakeup source supported by Module. „1‟ represents TURN ON and „0‟ represents
TURN OFF. Details are defined as following table”
Bit [4-15]
Bit[3]
Bit[2]
Bit[1]
Bit[0]
Reserved
UR
DATA
SMS
Voice
Default Value
3 (Support Voice+SMS)
12.1.4 Example
Query the current configuration parameters:
AT^WAKEUPCFG?
The wakeup function status is TURN ON. The hardware interface to wakeup is
WAKUP_OUT PIN. The supported remote-wakeup sources are Voice, SMS and
DATA.
^WAKEUPCFG: 1,1,7
Set the wakeup function status TURN ON. The hardware interface to wakeup is set
to USB. Supported remote-wakeup sources are Voice, SMS, DATA and UR.
AT^WAKEUPCFG=1,2,15
Configuration Succeed:
OK